1974 Caterpillar D7G Bulldozer
Takanini, North IslandPhoto gallery
Key details
- Odometer
- 1,721 HR Showing
- Transmission
- 3spd
- Engine
- 6 cyl Turbo
- Body
- Bulldozer
Item Location
Hornby, Christchurch, South Island
Sales Information
- Auction
-
Lot
National Agricultural and Civil Auction
View all units in this Sales Event - Start Time
- 14:00PM NZST on Wed 13 August 2025
- Stock No
- 7032036
- Before finalising your bidding/buying, please view the associated fees:
- Buyer Fee
- % of the purchase price 16.50% , min $75.00
- If purchase price is greater or equal to $5001 12.50%
- If purchase price is greater or equal to $40001 10.75%
Features
- Angle Tilt Blade
- Ripper
- Track
Details
- Build Year
- 1974
- Make:
- Caterpillar
- Body Type:
- Bulldozer
- Model:
- D7G
- Variant:
- Odometer:
- 1,721 HR Showing
- Transmission:
- 3spd
- Engine:
- 6 Cyl
- Fuel Type:
- Diesel
Info
- VIN
- 65V02505
Recall Disclaimer
Assets sold through Manheim auctions may be subject to a recall. Buyers are responsible for conducting their own searches on assets to determine whether a recall applies, including but not limited to checking the original equipment manufacturers' website, before deciding whether or not to participate in the auction. Further terms and conditions apply and are available here.
Comments
***Located at Manheim Christchurch*** ~1974 Caterpillar D7G Bulldozer Reported as built 1974, serial number 65V02505 - unable to locate ID stamp or plate to verify. -Dozer runs and drives, three speeds in forward and reverse all work, hydraulics seem to work as they should. -In need of work, issues include but aren't limited to: -No batteries so requires jump pack to start. -Left final drive worn, pops and bangs during use. -Outside rippers not attached, middle ripper damaged. -Ball joints for top attachment point to the blade are very worn. all -Joints/bushes on blade likely worn. -Has got damage/rust on left side of chassis as pictured. -No screwable fuel cap, has got a rag stuffed in filler hole and then the standard flip cap over it, it is protected from the elements. -Came in with low coolant, water added once on site, unknown amount of use with low coolant. -Hydraulic fluid appears low. -General damage/wear & tear on body as expected for age. -Tracks 560mm wide. -Blade 3400mm wide, 1140mm tall on outside edge & 1660mm tall at center. Selling under instructions from the finance company, PPSR will be removed at point of sale. Inspection recommended via appointment only. Manheim contact - Brian Taylor - 027 470 7084.